Table of Contents
Advertisement
4. Slide the table extension toward
the table until it rests against the
saw table.
5. Lock both cam locking levers by
pushing them in toward the cam
locking lever assemblies.
6. If the extension is not level to
the table, adjust by inserting the
spacers (Carton Contents R)
between the extension and the tube
it mounts onto. See page 42.
7. Make sure the screw (3) into the
matching hole (4) of the extension
mounting tube (2).
8. Install the left hand table extension
the same manner.
Fig. O
4
3
1
INSTALLING THE REAR OUTFEED
SUPPORT (FIG. P, Q)
1. Insert the two rear outfeed support
tubes (2) into the rear outfeed
support (1). (Fig. P)
NOTE: They must be inserted into
the back of the support with the
dimple end last so that the bar will
hold the support in place.
2. Snap two black plastic stops (3)
over the two rear outfeed support
tubes (2). Make sure the locating
pin in the black plastic stops fits into
the matching hole in the support
tube. This will "lock" the tube into
the support. (Fig. P)
Fig. P
3. Insert rear outfeed support tubes (2)
into the two holes in the rear of the
2
saw table, and into the extension
tube brackets under the table.
Position the rear table support so
that the instruction labels are facing
up. (Fig. Q)
4. Tighten one rear outfeed support
stop screw (4) on the end of the
left rear outfeed support tube (2).
Verify that the screw is fully inserted
into the corresponding hole in the
support tube. (Fig. Q)
Fig. Q
25
25
Dimple End
1
3
2
3
3
2
4
1
Advertisement
Table of Contents
