Table of Contents
Advertisement
3.3. As shown, pull the inlet pipe of the Bidet seat through the
bowl and connect it to the valve hose connector on the
iron rack. Pull the plug of the Bidet seat through the bowl
and connect it to the socket on the iron rack and then fix
the Bidet seat.
Seat hardware: See fig.8
4. Place the new bowl on the wall through the carrier. Wrench
the nut to tighten and make them attached securely. See
Fig. 9.
·
Torque for tightening nuts is recommended to be within
the range from 8 Nm to 12 Nm.
Finished Wall
Adjust to horizontal and finish tightening. See Fig. 10a.
Apply sealant to make sure the bowl's edge seals to the wall.
See Fig. 10b.
1461371-T01-B
Fig.#7
7
Fig. #10a
10a
3.3.
4.
9
·
Fig. #9
9
-5-
(
)
8
Fig.#8
8
8Nm 12Nm
10a
10b
Fig. #10b
10b
Advertisement
Table of Contents
