hestan KRG485GD-LP Installation Manual page 6

LOCATION AND INSTALLATION / VENTILATION
The range is held onto the pallet with 4 large shipping bolts on both sides. Remove these bolts and
then move the range to the floor with the help of 2 persons.
EN
PREPARATION
Before moving the range, protect any finished flooring and secure the oven door(s) closed to
prevent damage.
GAS AND ELECTRICAL SUPPLY CLEARANCES
If not already in place, install a gas shut-off valve in
an easily accessible location for servicing of the range.
Make sure all users of the range know where this shut-
off is located, and how to shut off the gas. Any openings
in the wall or floor behind the appliance must be sealed.
The Installation Clearances on the following pages show
where the "G" and "E" zones should be located.
The range is designed to be installed nearly flush to the
rear wall*. It may be necessary to reposition the gas
supply and power receptacle / junction box in order to
accommodate the range when pushed back against the
wall.
The back of the range is recessed 3-1/4" [8.3 cm] to
provide room for the cord and gas pipe. If using a
wall-mounted junction box/outlet, it may need to be
mounted to direct the cord along the wall instead of
toward the range.
* Unless installed in an island with no rear wall.
CABINETRY
To eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space
located above the surface units should be avoided. If cabinet storage is to be provided, the risk can
be reduced by installing the required vent hood that projects horizontally a minimum of 5" [12.7
cm] beyond the bottom of the cabinets.
4
©2019 Hestan Commercial Corporation
GAS
SUPPLY
Grounding pin
3-Prong receptacle
Grounded receptacle box
Conduit
(CONTINUED)
SHUTOFF VALVE
IN OPEN POSITION
TO
APPLIANCE
3-1/4" max.
wall to back
of range
box mounted
against wall to
direct cord
along wall