Yamaha F350A Owner's Manual page 31

Pre-operation checks
Place the control lever in neutral and turn the
main switch to "
come on and the total hour display comes
on, the gauge will change to normal opera-
tion. If the buzzer sounds and the water sep-
arator-warning indicator blinks, consult your
Yamaha dealer immediately.
NOTE:
To stop the buzzer, press the "
" " (mode) button.
Adjusting trolling speed (for square type)
You can adjust the trolling speed randomly
by increasing or decreasing it approximately
50 r/min. When in the trolling speed setting
mode, the display switches to the normal dis-
play when the engine speed is increased
(within 3,000 r/min) using the throttle. When
the throttle is closed, the display returns to
the trolling speed setting mode. For details,
see the attached operation manual.
NOTE:
Trolling is affected by currents and other
G
operating conditions and may differ from
the actual engine speed.
The default engine idle speed is reset au-
G
tomatically when the display is switched to
the normal display. The default engine idle
speed is also reset automatically when the
engine is turned off or when the engine
" (on).After all the displays
" (set) or
ZMU05931
Basic components
speed exceeds 3,000 r/min.
When warming up a cold engine, the troll-
G
ing speed cannot be decreased below the
specified engine idle speed.
Low oil pressure warning
When the engine oil pressure drops too low,
the low oil pressure-warning indicator will
start to blink, and the engine speed will auto-
matically decrease to about 2000 r/min.
Stop the engine immediately if the buzzer
sounds and the low oil pressure-warning in-
dicator blinks. Check the engine oil quantity
and replenish oil if necessary. If the warning
device has activated while the appropriate
engine oil quantity is maintained, consult
your Yamaha dealer.
ECM01600
CAUTION:
Do not continue to run the engine if the
low oil pressure warning device has acti-
ZMU05430
ZMU05431
26