Table of Contents
Advertisement
• DO NOT take part in contact sports for 24 hours after treatment.
• DO NOT depilate (waxing, plucking, threading or creams) during the treatment - shaving
is acceptable as long as you avoid shaving 24 hours after each treatment.
• DO NOT use bleaching creams or perfumed products for 24 hours after treatment.
INFINITY BULB
INFINITY BULB
•
• The infinity bulb means no replacement parts are needed.
•
The bulb in this device is guaranteed to last for the entire warranty period as
communicated on the warranty details at the rear of this manual.
• The bulb in this device is guaranteed to last for the entire warranty
•
In the extremely unlikely event that your bulb becomes empty, please contact your
local Remington Service centre who will provide you with a replacement.
period as communicated on the warranty details at the rear of this
manual.
, Signs that the bulb needs replacing:
•
Bulb Status Indicator is illuminated yellow: 150 Flashes remain in the bulb
• In the extremely unlikely event that your bulb becomes empty, please
•
Bulb status indicator is
contact your local Remington Service centre.
CLEANING YOUR i-LIGHT® DEVICE
DO NOT use this appliance with components (e.g. lamps and body caps) that have not
been supplied by Remington as suitable for use with the appliance. If repair is required,
CAUTION: Before cleaning your i-LIGHT®, make sure that the device is switched OFF and the power
please contact your local Remington Customer Service Centre.
cord is disconnected from the device.
•
Regular cleaning helps to ensure optimal results and a long life for the i-LIGHT® device.
Signs that the bulb needs replacing:
•
To clean the Flash Window, use only the lint-free cloth included with your i-LIGHT® device. Take care
• Bulb Status Indicator is illuminated yellow: 150 Flashes remain in the bulb
•
For stubborn stains on the
• Bulb status indicator is yellow: Bulb is empty.
Use a small hand-held vacuum to remove dust and debris from the hand piece vents.
CLEANING YOUR i-LIGHT
glass or the metallic surface inside the Treatment Head.
CAUTION: The i-LIGHT® is a high voltage device. Never immerse in water. Never clean the unit or any of
CAUTION: Before cleaning your i-LIGHT
its parts under a tap or in a dishwasher.
device is switched OFF and the power cord is disconnected from the device.
, Storage
•
Switch
the unit, unplug and allow to cool for 10 minutes before storage.
• Regular cleaning helps to ensure optimal results and a long life for the i-LIGHT
•
Store the unit in a dry place at a temperature between 15º C and 35º C
Face & Body device.
• To clean the Flash Window, use only the lint-free cloth included with your i-LIGHT
TROUBLESHOOTING
PRO+ Face & Body device. Take care not to scratch or chip the Flash Window.
Scratches and chips can reduce the effectiveness of the unit.
•
Always read these instructions fully before using i-LIGHT®
•
Refer to this troubleshooting guide if you experience any problems with i-LIGHT®, as this section
addresses the most common problems you could encounter with i-LIGHT®. If you have followed the
20
instructions in this section and continue to experience problems, please contact the Remington®
yellow: Bulb is empty.
window, dampen a cotton swab with surgical spirit or rubbing alcohol,
PRO+ FACE & BODY DEVICE
®
Pro Face & Body, make sure that the
®
PRO+
®
®
Advertisement
Table of Contents
