Changing The Selections After The Program Has Started; Childproof Lock; Ending The Program Through Canceling; Inlet Water Filters - Beko WMD 66160 S Quick Start Manual

unbalanced distribution of laundry in the
machine.
Changing the selections after the
program has started
Turning the program knob while the program
is in a normal flow will not change the
program.
Switching the machine to standby mode
Press "Start/Pause/Cancel" button
momentarily to switch your machine to the
standby mode. Auxiliary functions can be
cancelled or selected in accordance with
the step the program is at. The door can be
opened if the water level is suitable. Laundry
may be added / taken out by opening the
door.
Door lock
The loading door can not be opened yet due
to safety reasons while the "Ready" lamp is
flashing. The loading door can be opened
once the "Ready" lamp starts lighting up
continuously.
Child-proof lock
You can protect the appliance from being
tampered by children by means of the child-
proof lock. In this case, no change can be
made in the running program.
The machine is switched to child-lock by
pressing the 1st and 2nd auxiliary functions
for 3 sec. "C on" (Child lock is activated) label
appears on the screen. The same symbol
will also be displayed whenever any button is
pressed while the machine is child-locked.
Child-proof lock lamp on the program follow-
up indicator will light up when the child-proof
lock is activated.
To deactivate the child-proof lock, press the
1st and 2nd auxiliary function buttons for 3
sec. "C OFF" (Child-proof lock is deactivated)
symbol appears on the screen. Child-proof
lock lamp on the program follow-up indicator
will go off when the child-proof lock is
deactivated.
Ending the program through
canceling
"Start/Pause/Cancel" button is pressed for
3 seconds to cancel the program. "Ready"
warning lamp flashes during canceling and
"End" will appear on the display.
5 Maintenance and cleaning
Detergent Drawer
Remove any powder residue buildup in the
drawer. To do this;
1. Press the dotted point on the siphon
in the softener compartment and pull
towards you until the compartment is
removed from the machine.
C
If more than a normal amount of water
and softener mixture starts to gather in
the softener compartment, the siphon
must be cleaned.
2. Wash the dispenser drawer and the
siphon with plenty of lukewarm water in
a washbasin.
3. Replace the drawer into its housing after
cleaning. Check if the siphon is in its
original location.

Inlet water filters

There is a filter at the end of each water intake
valve at the back side of the machine and also
at the end of each water intake hose where
they are connected to the tap. These filters
prevent the foreign substances and dirt in the
water to enter into the machine. Filters should
be cleaned as they get dirty.
• Close the taps.
• Remove the nuts of the water intake
hoses to clean the surfaces of the
filters on the water intake valves with an
appropriate brush.
• If the filters are very dirty, you can pull
them out by means of pliers and clean
them.
• Take out the filters on the flat ends of
the water intake hoses together with
the gaskets and clean thoroughly under
streaming water.
• Replace the gaskets and filters carefully
to their places and tighten the hose nuts
by hand.
9 - EN