10/03!01
WED 13:47
FAX 864
964
3314
RYOBI CUSTOMER SERVICE
[_013/015
CHUCK REMOVAL
Gee Figures f3, 14, and 15.
The chuck must be removed in order to use some
accessories, To remove:
II
Lock the switch trigger by placing the directionof
rotationselector,in center position. See F/gum 5.
El
Inserta 5/16 Inch or larger hex key wrenchintothe
chuck of yourdrilland tightenthe chuck jaws
securely.
•
Tap the hex key wrench sharply with a mallet in a
clockwisedirection. See F/gut's 13.This will
loosen the screw in the chuck for easy removal.
MALLET
KEYLESS CHUCK
CHUCK ,JAWS
HEXKEY
WRENGH
Fig. 13
•
Open chuck jaws and remove wrench. Remove
the chuck screw by turning It in a olockwise
direction. See F/gu,_a11,
Note: The screw has left harld threads.
Insert hex key wrench in chuck and tighten chuck
jaws securely. Tap sharply with a mallet in a
counterclockwise direction. This will loosen chuck
on the spindle, It can now be unscrewed by hand.
,.SeeF_gure 15.
Fig. 15
TO RETIGHTEN
A LOOSE CHUCK
The chuck may become loose on sp]ndla and develop
wobble. Periodicallycheck chuck screw for tight-
hess,
To tighten, follow these steps:
•
Lock the switch triggerby placing the direction of
rotationselector in center position, See F/gure 5.
II
O_en the chuck jaws.
•
Inserthex key wrenchinto chuck and tighten
chuckJaws securely. Tap hex key wrench sharply
with a mallet in a clookwise direction.This will
tightenchuck on the spindle.
•
Open the chuck jaws and remove hex key
wrenoh.
II
Tighten the chuck screw.
Note: The chuck screw has left hand threads.
Fig. 14
12