Craftsman 973.111430 Owner's Manual page 8

to/03io1 WED 13:45 FAX 864 964 3314 RYOBI OUSTO_R SERVICE _oo9/o15
SWITCH
See Figure 2.
To turn your ddll ON. depress the switchtrigger. To
turn it OFF, release the switchtrigger.
SELECTOR
Fig. 2
VARIABLE SPEED
This tool has a variable speed switchthatdelivers higher
speed and torquewith increasedtriggerpressure.Speed
iscontrolledby the amount of switch triggerdepression.
Note: You might hear e whistlingor ringingnolse from
the switch during use. Do not be concerned, this is a
normal part of the switch function.
TWO-SPEED GEAR TRAIN
See F_gure 3.
Your drill has a two-speed gear train designed for
drilUng or driving at HI or LO speeds. A slide switch is
located on top of your drill to select either HI or LO
speed. When using drill in the HI speed range, speed
will increase end unit will have less power and torque.
When using drill In the LO speed range, speed will
decrease and unit will have more power and torque.
Use HI speed for fast ddlling or driving applications
and LO speed for high power and torque applications.
LOSPEED TWOSPEED
HI SPEED _ GEARTRAIN(HI-I.O)
TO INSTALL BATTERY PACK
• Lock switoh tdgger on your drill byplacing the
directionof rotationselector in center position.
See Fi#um 5.
• Place battery pack in your drill. Alignraised rib
inside drill with groove on battery pack.
Sos Figure 4.
BAITERY PACK
LATCHES
DEPRESS LATCHES TO
RELEASE BAI"rERY PACK
Fig, 4
[] Make sure the latches on each side of your battery
pack snap in place and battery pack is secured in
ddll before beginning operation.
_IL drill,CAUTION: y°Urbe sure raised rib inside ddll aligns with
When placing battery pack in
groove on battery pack and latches snap into
plaoe properly. Improper assembly of battery
pack can cause damage to internalcomponents.
TO REMOVE BAI"TERY PACK
• Lock switch trigger on your ddll by placing the
direction of rotation selector in center position.
See Figure 5.
• Locate latches on end of battery pack and depress
to release battery pack from your ddll,
See F_Jm 4.
[] Remove battery pack from your drill.
Fig. 3
8