10/O3/O1
WED
13:45
FAX
864
964
3314
RYOBI
CUSTOMER
SERVICE
[_008/015
tools. Failure to do so could resultin objects
being thrown into your eyes, resulting in possible
serious injury.
&
o
a careless fraction of a second is sufficientto
inflict severe injury.
CHARGING
BA'I-FERY PACK
The battery pack for this tool has been shippedIn a
low charge conditionto prevent possible problems.
Therefore, you should charge It overnightpriorto use.
Note: Batteries will not reach full charge the first time
they ere charged. Allow several cycles (drilling
followed by recharging) for them to become fully
charged.
TO CHARGE
•
Charge battery pack only with the charger and
charging stand provided.
•
Make sure power supply is normal house
voltage,
120 volts, 80 Hz, AC only.
•
Connect charger to power supply.
•
Place battery pack in charging stand. Align raised
rib on battery pack with groove in charging stand.
See Figure 1.
• Press clownon battery pack to be sure contacts on
battery pack engage properly with contacts in
charging stand.
•
When properly cOnnected,the red light on charging
stand will turn on.
•
Note: ff cha_:jer does not chargebatterypeck, return
batterypack, chargerand chargingstand to your
nearest Sears RepoJr Center for electrioalcheck,
•
After normal usage, a minimum charge time of 10
hours Is required to recharge a completely
discharged tool.
• The battery pack will become slightly warm to the
touch while charging.This is normal and does not
indicate a problem.
•
Do not place charger In an ares of eXtreme heat or
cold, It will work best at normal room temperature.
• When batteries become fully charged, unplug
charger from power supply.