olympia electronics GR-108/12L/90 Quick Start Manual

''CLASSIC LIGHT'' SERIES FOR NON MAINTAINED / ΜΑΙΝΤΑΙΝΕD
TECHNICAL CHARACTERISTICS
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERIES (Ni-Cd)
BATTERY PROTECTION
INDICATIONS - CONTROLS
CHARGING TIME
MINIMUM AUTONOMOUS DURATION
ILLUMINATION SOURCE
EMERGENCY ILLUMINATION
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIALS
EXTERNAL DIMENSIONS
TYPICAL WEIGHT
GUARANTEE
GENERAL
These luminaires are used indoors (ta 40 C)
where emergency light is needed.
Each luminaire must be permanently connected
to mains power supply.
In normal operation the battery is charging and
the 2 yellow LED's light in the screen.
In case of a mains power supply failure the
luminaire will light the led strip automatically in
emergency mode. When the mains power
supply is restored the device turns to normal
operation.
MAINTAINED / NON-MAINTAINED
OPERATION
There is an option to select the maintained or
non-maintained operation by placing the jumper
to the appropriate place according to step 4
(page 2).
ΑΤΤΕΝΤΙΟΝ!!!
1. Operations for installation, maintainance or
testing must be done by authorized personnel
only.
2. The device must be connected to the mains
power supply through a fuse dependent by the
total amount of the line's power load.
3. It is suggested to check every month the
indication LED for battery charging, and by
Page 1 of 3
EMERGENCY LUMINAIRES
EN 60598-1, EN 60598-2-22, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3
Thank you for your trust in our products
Olympia Electronics - European manufacturer
o
(for LED MODULE Specifications see page 2)
GR-108/12L/90
220-240V AC/50-60Hz
2.5W / 3VA
3.6V/600mAh
From overcharge and deep discharge
Battery charging LED, TEST button
90 min
12 white LED's
40lm / 100lm
5 to 40 C
Up to 95%
ABS/PC, PC
262 x 100 x 69 mm
535gr
3 years (1 year for the battery)
pushing the TEST button to check the emergency
circuit. The led strip should: a) light with bigger
intensity as long as the TEST button is pressed
(maintained operation),
b) light as long as the TEST button is pressed
(non-maintained operation).
doesn't work as described above contact the
installer.
4. It is suggested to check every 6 months the
minimum autononous duration by disconnecting
the mains power supply. Count the time that the
led strip lights and in case of less time than the
minimum autonomous duration the battery must
be replaced. If the measured time is considerably
less than the minimum autonomous duration
contact the installer.
replacement, these must be replaced by parts of
the same type, by the manufacturer or by a
competent person.
5. In case of inactive use for a period greater than
2 months, disconnect the battery by pulling out
the battery's connector.
6. I s not allowed to discard batteries into t i
common trash bins, they must be
discarded only
points.
Do not incinerate.
GR-109/12L/180
3W / 3.5VA
3.6V/1Ah
24 h
3 hours
38lm / 100lm
IP20
o
545gr
If the luminaire
In case of battery or led strip
in battery recycling
923109004_09_010