Table of Contents
Advertisement
'A' fault codes
Follow the steps below to try and fix the issue.
PROBLEM
POSSIBLE CAUSE
Drain hose is
A20
crimped or bent.
Drain fault
Blocked drain
connection.
The waste water is
not draining out.
The turbidity
sensor is dirty and
requires cleaning.
Drain pump
is blocked.
Water tap not
A10
turned on.
No water
Insufficient water
supply pressure.
Water inlet hose is
crimped or bent, so
no or not enough
water gets to
the dishwasher.
Drain hose is not
connected correctly.
FAULT CODES
WHAT TO DO
Check the drain hose and straighten if needed.
Check that drain connection is free from blockages.
Ensure that the drain hose is connected in accordance
with the installation instructions.
Gently clean the turbidity sensor with a soft brush
(ie toothbrush) to remove any buildup.
Turbidity
sensor
Remove the drain filter and clear any water from
the drain.
Remove the sump insert and pump cover.
Remove any remnants of food or blockages from
the pump.
Take care in case sharp objects or fragments of glass
are blocking it, as these may cause injury.
Pump
cover
Ensure the water is connected and turned on.
Touch
to restart the dishwasher.
Check household water pressure.
Check the water inlet hose and
straighten if needed. Touch
the dishwasher.
Ensure that the drain hose is connected in accordance
with the installation instructions.
Sump
insert
to restart
37
Advertisement
Table of Contents
