Page 1
10220 KIT Dodge Dakota (2WD/4WD)*† 2005 – All Dodge Dakotas † 2006 - All Dodge Dakotas except Night Runner and R/T sub models † 2007 - All Dodge Dakotas except SXT and TRX4 sub models † 2008 - All Dodge Dakotas except Big Horn sub models †...
Dodge Dakota (2WD/4WD) L6370 WARNING: This product can expose you to the chemical Hexavalent Chromate, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov KIT CONTENT Make sure all the items shown in the photo are provided in your kit before starting the installation.
Page 3
Dodge Dakota (2WD/4WD) L6370 OR IN PART IS PROHIBITED. BRAKE CO. SURREY, B.C., CANADA DRIVER'S SIDE AIR SPRING ASSEMBLY Note: Parts O & P will be switched for the passenger side assembly. ECN: MATERIAL: WEIGHT: INTERPRET A AND TO PER ASM THIRD ANG...
Dodge Dakota (2WD/4WD) L6370 Thank you and congratulations on the purchase of an air suspension kit. Please read the entire installation manual prior to starting the installation to ensure you can complete the installation once started. Should you have any questions during the installation, please call 800.663.0096.
Page 5
Dodge Dakota (2WD/4WD) L6370 UNAUTHORIZED DISCLOSURE, USE OR MANUFACTURE IN WHOLE OR IN PART IS PROHIBITED. DRAWING DESIGN AND OTHER DISCLOSURES PROPERTY OF PACBRAKE CO. SURREY, B.C., CANADA ASSEMBLE THE INSTALLATION TOOL 3/4" Jam Nut X 2 (T) • The installation tool will align the upper and lower brackets as well as position the upper bracket for drilling the bolt holes.
Page 6
Dodge Dakota (2WD/4WD) L6370 • Secure the lower bracket (C) to the leaf spring with two U-bolts (I), four flat washers (M) and four nyloc nuts (N). (See driver's side air spring assembly, page 2). • Torque the nuts (N) to 20 ft-lbs (27 N•m). •...
Page 7
CUSTOMER PART #: IN WHOLE OR IN PART IS PROHIBITED. RTY OF PACBRAKE CO. SURREY, B.C., CANADA • Insert two self-threading bolts (J) into the top holes and tighten to 15 ft-lbs (20N•m), be careful not to overtighten. Torque the two lower bolts to 44 ft-lbs (60 N•m).
Page 8
CUSTOMER PART #: • The most common place to install it is to replace the license plate fasteners with the fill valves (Figure 7A). DRAWING DESIGN AND OTHER DISCLOSURES PROPERTY OF PACBRAKE CO. SURREY, B.C., CANADA • Alternatively, two ⁄...
Page 9
Dodge Dakota (2WD/4WD) L6370 • Route one end of the nylon hose from the inflation valve to an air spring fitting (Q). Cut the hose and connect it to the air spring fitting (Q). Repeat with the other fill valve. •...
Page 10
Dodge Dakota (2WD/4WD) L6370 AFTER THE INSTALLATION IS COMPLETE PLEASE REMEMBER • Install the wheels, and torque the fasteners to the manufactures specifications. • Re-torque all the fasteners after the first 500 miles of driving. • For safe and proper operation, never operate the vehicle under the minimum of 10 PSI or over the maximum of 100 PSI.
Need help?
Do you have a question about the 10220 KIT and is the answer not in the manual?
Questions and answers