3.
Basic Setup
3.1 Power-On Initialization
As shown in the diagram below, after you plug in the power cord, the tally
light in the front will start flashing red and will be OFF as soon as the power-
on initialization is complete. The camera head should be at the HOME position
with the lens facing front. If the power is inserted, the camera lens will go
back to the position where the camera power is off last time. Note: After
powering-on, you need to wait for about 45 seconds, and then the image
which is shot by the PTC-305T will be shown on the connected monitor.
3.2
Video Output
You are allowed to view the camera video via NDI® | HX3/DVIP/LAN, 4K
HDMI OUT and 3G-SDI OUT.
NDI® | HX3/DVIP/LAN Port
Connect the DC 12 V power
adapter
14