Clutch Lever - Yamaha WR250R 2007 Owner's Manual

Right
1
2
1. Engine stop switch " / "
2. Start switch " "
Dimmer switch " / "
Set this switch to " " for the high
beam and to " " for the low beam.
Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
INSTRUMENT AND CONTROL FUNCTIONS
Horn switch "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
Start switch "
Push this switch to crank the engine
EAU12400
with the starter.
CAUTION:
See page 5-1 for starting instruc-
tions prior to starting the engine.
EAU12460
"
The engine trouble warning light will
". When re-
come on when the key is turned to "ON"
and the start switch is pushed, but this
does not indicate a malfunction.
EAU12500

Clutch lever

"
EAU12660
/ "
" before starting
" to
EAU12710
1. Clutch lever
"
The clutch lever is located at the left
handlebar grip. To disengage the
clutch, pull the lever toward the handle-
ECA10050
bar grip. To engage the clutch, release
the lever. The lever should be pulled
rapidly and released slowly for smooth
clutch operation.
The clutch lever is equipped with a
EAU41700
clutch switch, which is part of the igni-
tion
page 3-18.)
3-9
1
circuit cut-off system.
EAU12820
2
3
4
5
6
7
8
(See
9