Yamaha WR250R 2007 Owner's Manual page 51

2
1. Oil filter element cover
2. Oil filter element cover bolt
6. Remove and replace the oil filter
element and O-rings.
NOTE:
Make sure that the O-rings are properly
seated.
PERIODIC MAINTENANCE AND MINOR REPAIR
1
1
1. O-ring
2. Oil filter element
7. Install the oil filter element cover by
installing the bolts, then tightening
them to the specified torque.
Tightening torque:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
8. Install the engine oil drain bolt, and
then tighten it to the specified
torque.
Tightening torque:
Engine oil drain bolt:
20 Nm (2.0 m·kgf, 14.5 ft·lbf)
9. Add the specified amount of the
recommended engine oil, and then
2
NOTE:
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
CAUTION:
6-11
install and tighten the oil filler cap.
Recommended oil:
See page 8-1.
Oil quantity:
Without oil filter element replace-
ment:
1.30 L (1.37 US qt) (1.14 Imp.qt)
With oil filter element replacement:
1.40 L (1.48 US qt) (1.23 Imp.qt)
G
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
G Make sure that no foreign mate-
rial enters the crankcase.
2
3
4
5
ECA11620
6
7
8
9