Table of Contents
Advertisement
•
Grasp the mulch plug by its handle and lift clear
of the rear axle of the lawnmower.
•
Guide the mulch plug out over the rear axle of
the lawnmower.
•
Lower the rear flap or fit the catcher as
required.
•
Clean the underside of the mower body and
mulch plug as necessary.
TO INSTALL BATTERY PACK
O INSTALL BATTERY PACK
1.
Lift and hold up the battery door.
Lift and hold up the battery door (1).
2.
Align the battery with the mower's battery port
Align the battery (2) with the mower's battery port.
Make sure the battery release button (3) snaps in place and that battery is fully seated and
3.
Make sure the battery release button snaps in
secure in the mower before beginning operation.
If the machine is not going to be used immediately, remove the battery.
place and that the battery is fully seated and
secure in the mower before beginning operatio
O REMOVE BATTERY PACK
Release the bail lever to stop the mower.
Press the battery release button (3) on the mower. Open the battery door.
NOTE: If the machine is not going to be used
Remove battery from the mower.
immediately, remove the battery.
2
TO REMOVE THE BATTERY PACK
•
Release the drive levers to stop the mower.
•
Open the battery door
•
Press the battery release button on the mower.
•
Remove battery from the mower.
BLADE CARE
Check the condition of the blades, bolts and cutter
assembly regularly. Remember that badly worn
blades will affect grass cutting, catcher fill and cause
excessive mower vibration.
Change worn or damaged blades.
WARNING - Always remove the battery when working
on the blade assembly. This will prevent accidental
engine start.
10
1
3
BAR BLADE ASSEMBLY
1.
Tip the lawnmower on its side.
2.
Remove the centre bolt; pull the blade and
carrier off the engine shaft.
3.
Either sharpen and balance the old blade or fit
a new one.
4.
Grease the engine shaft; assemble in reverse
order.
5.
Torque the centre bolt to 50 Nm.
NOTE: It is recommended that you use an authorised
Service Agent for any replacement, sharpening or
balancing blade work.
Blade Replacement Torque Settings
Centre Bolt 50 Nm
USING THE PRODUCT
Starting/Stoping The Mower
To Start The Motor:
•
Open the battery door.
•
Insert the battery.
•
Insert the key.
•
Squeeze the left drive lever (A) toward the
handle and hold there, then squeeze the right
drive lever toward the handle (B) and hold there
to start the lawnmower.
To Stop The Motor:
•
Release both drive levers.
Soft-Start
This LI-ION mower is equipped with a "soft- start"
feature. When initially starting up, the mower will
take approx. 3 seconds to get up to full speed. If the
mower does not initially start: Remove the battery
and check under the mower deck to ensure there is
nothing obstructing the blade and that the blade can
spin freely by hand. Even a small amount of grass on
start up will prevent the "soft-start" from turning the
mower on.
Advertisement
Table of Contents
