Advertisement
Low-Touch Provisioning Using Management Port
b) When prompted, log in with the username install and the password <chassis_serial_number>.
The <chassis_serial_number> can be obtained by inspecting a tag on the chassis.
c) Complete the system configuration as prompted.
• Strong password enforcement policy (for strong password guidelines, see
• Password for the admin account.
• System name
• Supervisor Management IPv4 address and subnet mask, or IPv6 address and prefix.
• Default gateway IPv4 or IPv6 address.
• Host/network address and netmask/prefix from which SSH access is allowed.
• Host/network address and netmask/prefix from which HTTPS access is allowed.
• DNS Server IPv4 or IPv6 address.
• Default domain name.
d) Click Submit.
Step 4
To configure your system using SSH:
a) Connect to the management port using the following command:
ssh install@<ip_address>
where <ip_address> is the IP address of the management port on the Firepower 4100/9300 chassis that
was assigned by your DHCP server.
b) When prompted, log in with the password Admin123.
c) Complete the system configuration as prompted.
Note
Example:
This setup utility will guide you through the basic configuration of
the system. Only minimal configuration including IP connectivity to
the FXOS Supervisor is performed through these steps.
Type Ctrl-C at any time for more options or to abort configuration
and reboot system.
To back track or make modifications to already entered values,
complete input till end of section and answer no when prompted
to apply configuration.
You have chosen to setup a new Security Appliance.
Getting Started
6
You can optionally enter the debug menu at any time during initial configuration to debug
any setup issues or abort configurations and reboot the system. To enter the debug menu,
press Ctrl-C. To exit the debug menu, press Ctrl-D twice. Note that anything you type in the
interim between pressing Ctrl-D the first time and pressing it a second time will run after the
second time Ctrl-D is pressed.
---- Basic System Configuration Dialog ----
Continue? (yes/no): y
Getting Started
User
Accounts) .
Advertisement
