Advertisement
Getting Started
Procedure
Step 1
Power on the chassis.
Step 2
Connect to the serial console port using a terminal emulator.
The Firepower 4100/9300 includes an RS-232–to–RJ-45 serial console cable. You might need to use a third
party serial-to-USB cable to make the connection. Use the following serial parameters:
• 9600 baud
• 8 data bits
• No parity
• 1 stop bit
Step 3
Complete the system configuration as prompted.
Note
Example:
This setup utility will guide you through the basic configuration of
the system. Only minimal configuration including IP connectivity to
the FXOS Supervisor is performed through these steps.
Type Ctrl-C at any time for more options or to abort configuration
and reboot system.
To back track or make modifications to already entered values,
complete input till end of section and answer no when prompted
to apply configuration.
You have chosen to setup a new Security Appliance.
Enforce strong password? (yes/no) [y]: n
Enter the password for "admin": Farscape&32
Confirm the password for "admin": Farscape&32
Enter the system name:
Supervisor Mgmt IP address : 10.80.6.12
Supervisor Mgmt IPv4 netmask : 255.255.255.0
IPv4 address of the default gateway : 10.80.6.1
The system cannot be accessed via SSH if SSH Mgmt Access is not configured.
Do you want to configure SSH Mgmt Access? (yes/no) [y]: y
SSH Mgmt Access host/network address (IPv4/IPv6): 10.0.0.0
You can optionally enter the debug menu at any time during initial configuration to debug any
setup issues or abort configurations and reboot the system. To enter the debug menu, press Ctrl-C.
To exit the debug menu, press Ctrl-D twice. Note that anything you type in the interim between
pressing Ctrl-D the first time and pressing it a second time will run after the second time Ctrl-D
is pressed.
---- Basic System Configuration Dialog ----
Continue? (yes/no): y
firepower-9300
Initial Configuration Using Console Port
Getting Started
3
Advertisement
