Advertisement
1.1 Function of LEDS
2. MAIN FUNCTIONS
2.1 HOW TO SEE THE SETPOINT
1. Push and immediately release the SET key: the display will show the set point value.
2. Push and immediately release the SET key or wait for 5 seconds to display the
sensor value again.
2.2 HOW TO CHANGE THE SETPOINT
1. Hold the SET key for more than 2 seconds to change the set point value.
2. The value of the set point will be displayed and the
3. To change the set value push the
4. To set a new point value, push the SET key again or wait 10s.
2.3 HOW TO START A MANUAL DEFFROST
Hold the
key for more than 2 seconds and the manual defrost will start
2.4 HOW TO LOCK THE KEYBOARD
1. Hold the
and
2. The "POF" message will be displayed and the keyboard will be locked. At this point, it will be possible only
to see the set point or the MAX or Min temperature stored.
3. If a key is pressed more than 3s the "POF" message will be displayed.
2.5 HOW TO UNLOCK THE KEYBOARD
Hold the
and
3. ALARM SIGNALS
HOW TO SEE THE ALARM AND
RESET THE RECORDED ALARM
1. Hold the
or
display the alarm signals.
2. When the signal is displayed, hold
the SET key until the "rst" message
is displayed, and push the SET key
again. The "rst" message starts
blinking and the normal temperature
will be displayed.
8
or
keys for more than 3s.
keys together for more than 3s, till the "POF" message is displayed.
key to
LED starts blinking.
key within 10s.
Service and Installation Manual
Advertisement
