Advertisement
Hopper*
Chipper C hute
Discharge Chute
Bottle
of Oil
Safety
Glasses
Catcher Bag
* The hopper is packed in the top insert
in your chipper-shredder carton.
Figure 1
IMPORTANT: This unitis shippedwithout gasoline
or oil in the engine, Al_erassembly, see
OPERATION sectionof this manual for proper fuel
and engine oilfill-up.
NOTE: To determine rightand left hand sides of your
chipper-shredder, stand behind the unit with the
engine farthest away from you.
Yourchipper-shredder h asbeen completely assembled
at the factory, exceptforthe hopperassembly,chipper
chute,discharge chuteand the catcherbag.
These parts are shippedloosein the carton. A pairof
safety glasses and a bottle ofoil are also includedin
the canon.
UNPACKING FROM CARTON
Cut the corners of the canon.
Remove all packing inserts.
Remove all loose parts includingowner's
manual. See figure 1.
Roll chipper-shredderout of the canon.
Make certainall parts and literaturehave been
removedbefore the cartonis discarded.
LOOSE PARTS
(Refer to figure 1.)
a, Hopper Assembly
b. DischargeChute
c. Chipper Chute
d. Catcher Bag
e. Bottle of Oil
f.
Safety Glasses
g. Owner's Manual (not shown in figure 1)
TOOLS REQUIRED
1.
1/2"or AdjustableWrenches
2.
7/16" or AdjustableWrenches
3.
9/16" or AdjustableWrenches
4.
Funnel
DISCONNECTING
SPARK PLUG
Disconnect the spark plug wire and move it
away from the spark plug before assemblingthe
chipper-shredder. See figure 2.
Spark PlugWire
Figure 2
ATTACHING
DISCHARGE
CHUTE
Remove the wing knobs from each side of the
discharge opening on the chipper-shredder.See
figure 3.
Using two 7/16" wrenches, remove hex locknut,
two spacers, and the bex bolt fromtop of the
housingassembly. For easy assembly,do not
remove the second spacer from the hex bolt.
Place the discharge chute in positionon the
dischargeopening. Inserthex boltand spacer
Advertisement
