Advertisement
Operation
Installing and Removing
the Weights
Sand Pro 2040Z Only
Always ensure that your machine has the appropriate
number of weights.
Refer to the following table for how many weights are
required on the front of the machine:
Attachment
Flex tooth rake
Flex tooth rake with finish
brush
Nail drag
Nail drag with finish drag mat
Note:
Sand Pro machines other than the 2040Z do
not require the additional weights included in this kit.
1.
Remove the 2 bolts and 2 nuts securing the
existing weights on the front of the machine
(Figure
9).
Note:
If the machine is equipped with the light
kit, remove the nut and the bolt securing the
front light to the machine. Retain all of the parts;
refer to the Light Kit Installation Instructions.
Number of weights required
4
6
6
8
2.
Add or remove weights as necessary.
3.
Secure the weights with the 2 bolts and the 2
nuts.
Note:
If the machine is equipped with the light
kit, install the front light by inserting the bolt
through the weights and securing it with the nut;
refer to the Light Kit Installation Instructions.
Adjusting the Lift-in-turn
System
Sand Pro 2040Z Only
Ensure that the tires are inflated to 48 kPa (7 psi), and
ensure that the lift-in-turn height is adequate; refer to
the rake Operator's Manual.
4
Figure 9
g023729
Advertisement
