Leuwico go2basic User Manual page 23

TROUBLESHOOTING MOTOR ADJUSTMENT
Drives not working
Possible cause
Power cord is not connected
Drives are not connected
Poor plug contact
Motor adjustment is defective
Control panel is defective
Drives run in one direction only
Possible cause
Mains power breakdown or mains power is plugged
off during movement
Motor adjustment is defective
Control panel is defective
Drive is defective
*) If movement is only possible downwards
Motor adjustment or control panel is not working
Possible cause
Power cord is not connected
Control panel is not connected
Motor adjustment is defective
Power cord is defective
Control panel is defective
Poor plug contact
Error messages on the control panel display
Cause
Initial operation or separation from the power
Remedy
Plug the power cord into the motor adjustment
Plug the motor cables into the motor adjustment
Plug the motor cables, power cord and
control panel in properly
Contact customer service. Have the order confirmation and
deck type ready for this purpose (see type label)
Replace the control panel; contact customer service� Have
the order confirmation and deck type ready for this purpose
(see type label)
Remedy
Manual reset *)
Contact customer service. Have the order confirmation and
deck type ready for this purpose (see type label)
Replace the control panel
Contact customer service. Have the order confirmation and
deck type ready for this purpose (see type label)
Contact customer service. Have the order confirmation and
deck type ready for this purpose (see type label)
Remedy
Plug the power cord into the motor adjustment
Plug in the control panel
Contact customer service. Have the order confirmation and
deck type ready for this purpose (see type label)
Contact customer service. Have the order confirmation and
deck type ready for this purpose (see type label)
Replace the control panel� contact customer service� Have
the order confirmation and deck type ready for this purpose
(see type label)
Connect the plugs properly
Remedy
The display reads 000
Press the button „down" and move the desk top down to the
lowest desk position� Stay another 3 seconds on the button�
Already memorized working heights have to be restored
23