LG R3-PRIME Owner's Manual page 16

global_main.book.book Page 16 Monday, July 10, 2023 3:22 PM
OPERATION
16
2
Wet the mop pad and wring it out until it stops
dripping. Install the mop pad along the slot of
the holder and fix it tight.
• Before attaching the mop, wet the mop with
enough water and wring the mop.
3
Insert the mopping module into the bottom of
the robot cleaner until you hear a click.
• After inserting the mopping module, the
robot cleaner will automatically switch to the
mopping mode.
4
Select the sweeping mode to start sweeping.
• The robot cleaner will automatically sweep
and mop the floor in the selected mode.
• Adjust the mopping water level in the APP
according to needs.
• To achieve better cleaning, let the robot
cleaner sweep the floor 3 times and then
install the mopping module.
CAUTION
• If the mop pad is excessively wet, the floor may
become slippery and cause people to slip.
• Do not leave the robot cleaner in the home
station or on the floor for a long time with wet
mop pad attached. Doing so may cause floor
damage or odours.
Drying the Water Tank and
Washing the Mop Pad
1
When the robot cleaner returns to the charging
dock after finishing the cleaning cycle, hold the
clip on both sides and drag it backwards to
remove the mopping module.
• When the mopping module is removed, the
robot cleaner will automatically exit the
mopping mode without water leakage.
2
Empty the remaining water in the water tank.
3
Clean the mop pad and allow it to dry
completely to avoid mildew and odours.
CAUTION
• Do not dry the mop pad in a dryer. Doing so may
damage the mop pad.
• Do not forcefully remove the water tank cap
from the water tank.
• Although water discharge is stopped when
sweeping is stopped, the mop pad is still wet. Be
careful not to leave the robot cleaner in one
place for too long, as excessive moisture from
the mop will damage the floor.