Transportation, Storage And Disposal - RedMax RZT42 Operator's Manual

Hide thumbs Also See for RZT42:
Table of Contents

Advertisement

Available languages

Available languages

Problem
The cutting result is unsatisfactory.
Transportation
The product is heavy and can cause crush
injuries. Be careful when you load it onto or off
a vehicle or trailer.
Load the product in reverse on approved ramps
of a maximum operation angle of 10°. Do not lift
the product.
Use an approved trailer for transportation of the
product.
Make sure that you have knowledge of local
road traffic regulations before transportation of
the product in a trailer or on roads.
Stop the fuel supply of the product.
Lock the product with approved devices, such as
straps. Use tie-down points on the product. The
parking brake is not sufficient to lock the product
during transportation.
To tow the product
WARNING:
product, you must read and understand
the safety chapter. Refer to
on page 9 .
Be careful when you tow the product.
Operate the product slowly when you tow the
product.
The breaking distance increases when you tow
the product. Make sure to decreases the speed
in time.
For safe operation, do wide turns.
Do not tow near ditches, open water, and other
dangerous areas.
2236 - 001 - 18.08.2023
Cause
The tire pressure is different on the right and left sides. Refer to
Tire pressure on page 18 .
The blades are damaged.
The suspension of the cutting deck is not level.
The blades are blunt. Refer to
19 .
The product is operated at too high forward or rearward speed.
Refer to
The grass is long. Refer to
14 .
There is grass blockage in the cutting deck. Refer to
the product on page 16 .

Transportation, storage and disposal

Before you tow the
Tow safety
To examine the blades on page
To get a good cutting result on page 14 .
To get a good cutting result on page
Storage
Prepare the product for storage at the end of the
season, and before more than 30 days of storage. If
you keep fuel in the fuel tank for 30 days or more,
tacky particles can cause blockage in the carburetor.
This has a negative effect on the engine function.
To prevent tacky particles during storage, add a
stabilizer. If alkylate gasoline is used, stabilizer is
not necessary. If you use standard gasoline, do
not change to alkylate gasoline. This can cause
sensitive rubber parts to become hard. Add stabilizer
to the fuel in the tank or in the container used for
storage. Always use the mixing ratios given by the
manufacturer. Add the stabilizer and run the engine
for a minimum of 10 minutes, until the fuel flows into
the carburetor.
WARNING:
product with fuel in the tank in an indoor
location or in locations with bad airflow.
Risk of fire if fuel fumes come near
open flames, sparks, or pilot lights in
for example boilers, hot water tanks and
clothes dryers.
WARNING:
and other flammable materials from the
product to decrease the risk of fire. Let
the product become cool before you put
it in storage.
Clean the product, refer to
on page 16 .
Remove unwanted materials from the cooling
fan.
Repair paint damages to prevent corrosion.
To clean
Do not keep the
Remove grass, leaves
To clean the product
25

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents