RedMax RZT42 Operator's Manual page 11

WARNING:
product, you must make sure that there
are no stones or other objects in the
work area that can be thrown by the
rotating blades.
• Do the daily maintenance. Refer to
schedule on page 14 .
• Make sure that there is sufficient fuel in the fuel
tank.
• Set the cutting height. Refer to
height on page 12 .
To fill fuel
WARNING:
flammable. Be careful and refuel
outdoors, refer to
WARNING:
exhaust system become very hot during
operation. Risk of burn injury. Let the
engine and the exhaust system become
cool before you fill fuel in the product.
WARNING:
tank as a support area.
CAUTION:
result in engine damage.
The engine runs on gasoline with a minimum octane
rating of 91 RON (87 AKI), not mixed with oil. We
recommend biodegradable alkylate gasoline.
• Do a check of the fuel level before each use and
refuel if it is necessary.
• Do not fill the fuel tank fully. Fill to the bottom of
the fuel tank neck.
To adjust the seat
1. Lift the seat up and remove the seat adjustment
knob (A).
2236 - 001 - 18.08.2023
Before you operate the
Maintenance
To set the cutting
Gasoline is very
Fuel safety on page 9 .
The engine and the
Do not use the fuel
Incorrect type of fuel can
2. Loosen the seat adjustment knob (B).
A
3. Move the seat until it is in the correct position.
4. Line up the hole in the seat plate for seat
adjustment knob (A) with the hole in the seat.
5. Install and tighten the seat adjustment knob (A).
6. Tighten the seat adjustment knob (B).
To fold the seat
The seat can be folded forward to get access to the
battery and hydrostatic gears.
1. Park the product on level ground.
2. Push the seat forward to fold the seat forward.
To engage and disengage the
parking brake
• Pull the parking brake lever rearward to engage
the parking brake. Refer to
page 3 for the location of the parking brake.
Note:
The product must be stationary when
you engage the parking brake.
• Push the parking brake forward to disengage the
parking brake.
To disengage and engage the drive
system
CAUTION:
engage the drive system when the
product is parked on level ground.
If it is necessary to move the product by hand, with
the engine off, the drive system must be disengaged.
The drive system is disengaged and engaged by
the bypass linkage. The bypass linkages are found
below the rear engine guard.
Follow the procedure below to disengage the drive
system.
B
Product overview on
Only disengage or
11