Maintenance - RedMax RZT42 Operator's Manual

To get a good cutting result
• For best performance, do maintenance on the
product regularly as given in the maintenance
Maintenance on page 14 .
schedule. Refer to
• Do not cut a wet lawn. Wet grass can give a bad
cutting result.
• Start with a high cutting height and decrease it
gradually.
• Use full throttle when you cut the grass.
• Move the product forward at low speed if the
grass is high and thick.
• Cut the grass in an irregular pattern.
• When you cut large areas, move the product
to the right during 1 or 2 turns around
the work area. This procedure will keep the
grass discharge away from shrubs, fences and
driveways. After approximately 2 turns around
the work area, cut in the opposite direction.
Introduction
WARNING:
maintenance work you must read and
understand the safety chapter.
Maintenance schedule
* = The instructions are not given in this operator's
manual.

Maintenance

Do a check of the parking
brake.
Do a check of the level of
the engine oil.
Do a check of the safety
system.
Make sure that there are
no fuel or oil leaks from
the product.
14
Maintenance
Before you do any
Daily maintenance
Before After
X
O
X
*
• When the mulch kit is used, cut the grass more
frequently.
• To get the best cutting result, cut the grass
frequently.
X = The instructions are given in this operator's
manual.
O = Refer to the engine manual for instructions.
Maintenance schedule for the operator
Do maintenance
at a minimum of 1
25
time each year
Maintenance interval in hours
50 100
2236 - 001 - 18.08.2023
300