Related Manuals for K-array Lyzard-KZ14W
Summary of Contents for K-array Lyzard-KZ14W
- Page 1 Lyzard-KZ14 USER GUIDE Ultra-miniature aluminum line array with four 0.5″ cone drivers...
- Page 2 KZ14_uguide_1.2...
-
Page 3: Table Of Contents
Lyzard-KZ14 User Guide Index Unpacking Setup Installation Adhesive strips Permanent installation, wall plug Connecting Loudspeakers in parallel Service Cleaning Mechanical drawings Technical specifications... - Page 4 • K-array cannot be held responsible for damage caused by improper This device complies with Restriction of Hazardous use of the loudspeakers.
- Page 5 Lyzard-KZ14 User Guide Thank you for choosing a K-array product! To ensure proper operation, please carefully read this reference manual and safety instruction before using the product. After reading this manual, be sure to keep it for future reference. Should you have any questions about your new device please contact K-array customer service at support@k-array.com or contact the official K-array distributor...
-
Page 6: Unpacking
Lyzard-KZ14 User Guide Unpacking Setup Each K-array product is built to the highest standard and Lyzard-KZ14 performs best when positioned on a planar thoroughly inspected before leaving the factory. Upon arrival, surface such as a wall. carefully inspect the shipping carton. If you find any damage, Find the proper installation height, aiming the loudspeaker at immediately notify the shipping company. -
Page 7: Installation
Lyzard-KZ14 User Guide Installation Adhesive strips 2. Drill a 4 mm (0.15 in) diameter hole in the surface with a The adhesive strips are intended for quick and clean deep of at least 20 mm (0.80 in); installation on flat surfaces. Two strips are provided: the double-sided removable adhesive strip and the magnetic strip are ready to use for either fixed and temporary installations. -
Page 8: Connecting
Lyzard-KZ14 is already pre-wired with 5 m (16.4 ft) of ultra- Caution must be taken when connecting the loudspeaker thin speaker cable to be directly connected to any K-array cable to the amplifier’s terminal to match the signal polarity: power amplifier. -
Page 9: Service
Mechanical drawings To obtain service: 1. Please have the serial number(s) of the unit(s) available for reference. 2. Contact the official K-array distributor in your country: find the Distributors and Dealers list on K-array website. Please describe the problem clearly and completely to the Customer Service. -
Page 10: Technical Specifications
Lyzard-KZ14 User Guide Technical specifications General Type Line array Drivers 4x 0,5″ neodymium magnet woofer with 0.5″ voice coil Frequency Response 500 Hz – 18 kHz (-6 dB) Rated Power 15 W peak Maximum SPL 98 dB peak Nominal Impedance 16 Ω... - Page 12 Designed and Made in Italy K-ARRAY surl Via P. Romagnoli 17 | 50038 Scarperia e San Piero - Firenze - Italy ph +39 055 84 87 222 | info@k-array.com www.k-array.com...