Mounting The Indoor Unit; To Install The Mounting Plate; To Drill A Wall Hole - Daikin FTXA25C2V1BW Installation Manual

Note: Make sure that there are no obstacles within 500 mm under
the infrared signal receiver. They may influence reception
performance of the wireless remote control.
5.2

Mounting the indoor unit

5.2.1

To install the mounting plate

1 Install the mounting plate temporarily.
2 Level the mounting plate.
3 Mark the centres of the drilling points on the wall using a tape
measure. Position the end of tape measure at symbol " ".
4 Finish the installation by securing the mounting plate on the wall
using M4×25L screws (field supply).
h
a
155
a Recommended mounting plate fixing spots
b Pocket for the pipe port cover
c Liquid pipe end
d Gas pipe end
e Use tape measure as shown
f Tabs for placing a spirit level
g Unit center
5.2.2

To drill a wall hole

CAUTION
For walls containing a metal frame or a metal board, use a
wall embedded pipe and wall cover in the feed-through
hole to prevent possible heat, electrical shock, or fire.
NOTICE
Be sure to seal the gaps around the pipes with sealing
material (field supply), in order to prevent water leakage.
1 Bore a 65 mm large feed-through hole in the wall with a
downward slope towards the outside.
2 Insert a wall embedded pipe into the hole.
3 Insert a wall cover into the wall pipe.
CTXA-C(W)(B)(S) + FTXA-C(W)(B)(S)
Daikin room air conditioner
3P697375-6B – 2023.05
a b
c
f
a k l
INFORMATION
The removed pipe port cover can be kept in the mounting
plate pocket.
798
d e
605
a
g f
a
j
m a
± 400 mm
± 440 mm
± 450 mm
h Hole for embedded piping Ø65 mm
i Value for tape measure
j Position for tape measure at symbol " "
k Drain hose
l Liquid pipe
m Gas pipe
a b
c
a Wall embedded pipe
b Putty
c Wall hole cover
4 After completing wiring, refrigerant piping and drain piping, do
NOT forget to seal the gap with putty.
5 Unit installation
a
110
h
i a
150
Installation manual
5