Configuration Mode (Mode 3); Wake-Up Mode (Mode 4); Configuration Mode (Mode 5) - Ebyte E70-433T S Series User Manual

Chengdu Ebyte Electronic Technology Co,;Ltd

6.5 Configuration Mode (Mode 3)

Status M0=1 M1=1 M2=0
Transmitting Transmission not available, serial data received will be discarded.
Receiving Receiving is not available.
Configuring Parameter configuration can be made in configuration mode with specific instruction format and UART 9600, 8N1.
When entering other modes from configuration mode, the module will reconfigure parameters, AUX keeps low level during
Note configuration;
After configuration completed, it outputs high level, so users are recommended to check the AUX rising edge.

6.6 Wake-up Mode (Mode 4)

Status M0=0 M1=0 M2=1
Transmitting Transmission is available.
Receiving Receiving is not available.
Baud rate & air Under this mode, the baud rate and air data rate are independent, both receiver and transmitter can have different baud rate
data rate but same air data rate.
It can wake up the receiver under mode 6; wake up code will be added automatically before transmitting, the code number
Advantage
depends on the wake up time.
Disadvantage The transmission time is long, only applicable to wake up the receiver, not applicable for common data transmission.
Applications For waking up the receiver under WOR mode.
Under wake up mode, the single data packet length is 84 bytes (excluding the address and channel for directional
Note
transmission).

6.7 Configuration Mode (Mode 5)

Status M0=1 M1=0 M2=1
Transmitting Transmission is not available. Serial data received are considered as configuration command.
Receiving Receiving is not available.
Configuration Parameter configuration can be made in configuration mode with specific instruction format and UART 9600, 8N1.
Chengdu Ebyte Electronic Technology Co,;Ltd
Copyright ©2012–2023，
E70-433TxxSx user manual
19