KitchenAid RISE JDPSS246LL Owner's Manual page 9

Other Parts Needed (not provided):
Optional Accessory Parts Available:
Call us at our toll-free number or visit the brand website listed in
the Quick Start Guide for accessory and part information.
3/8" (9.5 mm) Compression x
3/4" (19 mm) Hose Fitting
with rubber seal and 90°
elbow (required to properly
connect household water line
to the dishwasher.)
Part no: W10685193
Household Wiring (Metallic)
Strain Relief to fit 7/8"
(22 mm) hole (required to
properly secure household
wiring to the dishwasher
terminal box.)
Part no: 4396672
NOTE: Use only UL Listed/
CSA Approved parts.
Moisture Barrier Tape
NOTE: Moisture barrier tape
is an optional, added level
of protection if installing a
dishwasher under a wooden
countertop. Recommended
but not required for wooden
countertop.
Part no: 4396277
Side Panel Kit
For enclosing the side of the
dishwasher when installing it
at the end of your cabinetry
(Whirlpool part number varies
with color).
First-Time Installations
Check local codes. Check existing electrical supply. See the
"Electrical Requirements" section. It is recommended that
electrical connections be made by a licensed electrical installer.
Additional Tools Needed:
Small tubing cutter
Cordless drill
Additional Parts Needed (not provided):
NOTE: If using a flexible braided hose, replace inlet hose after
5 years to reduce the risk of hose failure. Record hose installation
or replacement dates on the hose for future reference.
NOTE: Be sure to purchase only Whirlpool factory-certified
parts and accessories for your appliance. Your installation may
require additional parts. To order, refer to the contact information
referenced in your Quick Start Guide.
Wire stripper
1/2" (12.7 mm), 3/4" (19 mm),
and 1 1 / " (38 mm)
2
hole saw bits
Copper Tubing (3/8" O.D.
suggested) or Flexible
Braided Water Supply Line
Kit. Kit includes braided hose
and 3/8" compression x
3/4" hose fitting.
Part no: W10278635RP
Screw-Type Clamps 1 / "- 2"
1
2
(38 mm - 50 mm) (3 maximum)
Optional-Longer Drain Hose
(Maximum length 12 ft (3.7 m)
NOTE: Must meet AHAM/
IAPMO test standards, fit 1"
(25 mm) drain connection,
and be resistant to heat and
detergent.
Part no: W11381654
9