Prepare Dishwasher; Remove Access Panel And Insulation; Disconnect And Remove Drip Tray Assembly - KitchenAid RISE JDPSS246LL Owner's Manual

PREPARE DISHWASHER

WARNING
Tip Over Hazard
Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
8.
Put the dishwasher on its back
Helpful Tip: Remove all internal shipping material, drain hose,
installation kit, and handle (if included,) before laying on it's back,
and do not remove film on the door at this time.
Place cardboard under dishwasher until installed
in cabinet opening to avoid damaging floor covering.
Using two or more people, grasp sides of dishwasher door frame,
and place the dishwasher on its back.
Do not use the door panel as a worktable without first covering
it with a towel to avoid scratching the door panel.

REMOVE ACCESS PANEL AND INSULATION

9.
Remove access panels
Using a 5/16" (7.9 mm) nut driver, remove the two screws
attaching access panels to dishwasher. Once the screws are
removed push the access panel toward the top of the product to
unhook it and then remove it.
DISCONNECT AND REMOVE DRIP TRAY
ASSEMBLY
10a.
Remove drip tray assembly
Drip tray assembly
To remove the drip tray assembly, press the snap at each side
of the plastic tray in toward the center of the product and pull
toward yourself. Be sure not to pull too far or too hard as the float
switch wire is still connected at this time.
10b. Remove float switch wire
To remove the float switch wire, gently push the connector latch
tab (1) and then pull the connector (2) out of the housing. The
float itself should not be removed from the tray.
NOTE: Do not reinstall drip tray until instructed.
15