Complete Installation - KitchenAid RISE JDPSS246LL Owner's Manual

4. Attach drain hose to air gap with large
4
drain hose clamp (provided). Use pliers
to squeeze clamp open and move into
position.
5. Use a rubber hose (not provided) with
5
screw-type clamps to connect from air
gap to disposer inlet.
Option D: No waste disposer –
with air gap
Screw-type clamps
Waste tee
Drain trap
1 1. Connect rubber end of drain hose
to air gap.
Rubber
end
2. Attach drain hose to air gap with large
2
drain hose clamp (provided). Use pliers
to squeeze clamp open and move into
position.
3. Use a rubber hose (not provided) with
3
screw-type clamps (not provided) to
connect from waste tee to air gap.
26

COMPLETE INSTALLATION

46.
Air gap
Check that the power supply wire or cord does not touch
Large drain
dishwasher motor or the lower part of the dishwasher tub.
hose clamp
Rubber hose
connector
Reconnect float switch by aligning connector removed in Step 10
with the connector housing and pushing in until the locking tab is
Drain hose
visible over the back of the connector.
47.
NOTE: Before replacing the dip tray, ensure that there is no water
present in the tray.
To replace drip tray, align with snaps in side members and push
in toward unit. It is important that the black hoses are above the
drip tray on both ends once it is pushed all of the way in.
Reconnect float switch
Replace drip tray