Advertisement
A: Entering Setup Mode
If the dimmer has been powered up for LESS THAN 30 MINUTES see A1 below.
If the dimmer has been powered up for MORE THAN 30 MINUTES see A2 below.
Once in Setup Mode, options are selected by a series of 'clicks' of the dimmer push button. Each 'click' should be
approximately 1 second after the previous click.
A1: Dimmer has been powered up via mains 240Vac for LESS THAN 30 MINUTES
Step 1
Press and hold the dimmer push button for 10 seconds
Note: Connected lights will dim up or down, this is normal
Step 2
The white LED Indicators will blink ON/OFF twice per second. This indicates that
the dimmer is now in Setup Mode
Note: If more than one LEDsmart
all these devices will now enter setup mode. The blink ON/OFF will also be seen on
all other LEDsmart
The dimmer is ready for the settings to be adjusted as required. Go to the relevant
Step 3
setup function instructions
A2: Dimmer has been powered up via mains 240Vac for MORE THAN 30 MINUTES
Step 1
Press and hold the dimmer push button for 30 seconds
Note: This resets the Setup Entry time back to 10 seconds (for the next 30 minutes)
Note: Connected lights will dim up or down, this is normal
Step 2
The white LED Indicators will blink ON/OFF with twice per second. This indicates
that the dimmer is now in Setup Mode
Note: If more than one LEDsmart
all these devices will now enter setup mode. The blink ON/OFF will also be seen on
all other LEDsmart
Step 3
The dimmer is ready for the settings to be adjusted as required. Go to the relevant
setup function instructions
+
device is connected in parallel (see pages 5-7),
+
devices connected in parallel
+
device is connected in parallel (see pages 5-7),
+
devices connected in parallel.
Push Button Dimmer/Switch
9
Advertisement
