Advertisement
Wiring for two-way dimming and switching
To achieve two-way dimming and switching using LEDsmart
dimmers have an integrated switch, therefore no separate switches or additional strappers are required for two-way on/off
control.
New Installation – two-way dimming and switching
Two-way dimming and switching using LEDsmart
dimmers are simply wired in parallel.
Replacing existing two-way switching with two-way dimming/switching
When replacing existing two-way switching with two-way dimming/switching using LEDsmart
wires can be re-used. No new wiring is required. See the wiring diagrams below.
Existing two-way switching
Traditional two-way switching using standard rocker switch
mechanisms and strappers between the switches.
+
dimmers, the two dimmers are connected in parallel. Note that the
+
dimmers. Note the two-wire
Replacement two-way dimming/switching
Rocker switches replaced with LEDsmart+ dimmers using
the existing strapper wires. No new wiring required.
Push Button Dimmer/Switch
+
, the existing two-way 'strapper'
6
Advertisement
