Advertisement
Specifications
Nominal Line Voltage Amplitude Range
Line Voltage Frequency
Load Brightness Control Range
Rated Load
Minimum Load
Maximum cable distance from any
+
LEDsmart
device to the parallel
junction point
** Some LED lights do not turn off completely when used with two wire devices such as LEDsmart
the small amount of current which flows through the device to the load when switched off. The result with some
LED light sources can be a small amount of light output when the LEDsmart
is recommended that a Diginet 'Load by-pass' device (Item MMBP) is added to the lights / dimmer installation.
Compatible Load Types
Load Symbol
Load Types
Dimmable LED
Lamps
Electronic
Transformers
Standard iron-core
transformers
Toroidal iron-core
transformers
Incandescent
Dimmable CFLs
Incompatible Load Types
Ceiling Sweep Fans and Exhaust fans.
Multi-Gang De-Rating
Number of times per plate
1
2
3
4
5
6
220-240Vac
50Hz Nominal (47 – 53Hz)
0% to 100% (typical for LED loads)**
Refer Compatible Loads table (below)
1W
50m (for example, two dimmers can be separated by up to 100m provided that the
maximum distance from the furthest dimmer to the parallel junction point is no
more than 50m).
Max. Load
400W
400W
250W
300W
350W
400W
De-rating factor
No de-rating
0.85
0.7
0.55
0.4
0.25
Notes
The LED driver must be dimmable. Maximum permitted number
of drivers is 400W divided by the driver nameplate power rating.
Due to variety of LED lamp designs, maximum number of LED
lamps is also dependent on power-factor result when connected
to dimmer.
Due to variety of transformer designs, max LV lighting load is also
dependent on transformer efficiency.
Due to the variety of CFL designs, the maximum number is
make/model dependent.
In applications where multiple dimmers are installed in a
multi-gang plate, a de-rating factor is applied to the
maximum load as follows.
De-rating Example
+
Two LEDsmart
devices installed in a wall plate. The
maximum LED load which can be connected to each device =
400W x 0.85 = 340W per device.
Push Button Dimmer/Switch
+
. This is due to
+
is in the off position. If this occurs, it
11
Advertisement
