Assembly / Preparation; Operation; Battery And Charger - Texas A/S GT1080 User Manual

Table of Contents

Advertisement

Available languages

Available languages

Assembly / Preparation

1.
Unpack all parts and lay them on a flat, stable
surface.
2.
Remove all packing materials and shipping
devices, if applicable.
3.
Make sure the delivery contents are complete and
free of any damage. If you find that parts are
missing or show damage do not use the product
but contact your dealer. Using an incomplete or
damaged product represents a hazard to people
and property.
4.
Ensure that you have all the accessories and tools
needed for assembly and operation. This also
includes suitable personal protective equipment
5.
Plug in the battery, by pushing it down until you
hear a click.
6.
Remove the battery by push down the battery lock
bottom and pull up.
NOTE: Always remove the battery before doing any
maintenance.
Mounting of front handle (Fig. 2)
The front handle can be attached by pushing the
buttons (1) and press the handle part down on the
bracket. The front handle angle can be adjusted by
pushing the buttons (1) and tilt the handle.
Mounting of the guard (Fig. 3)
Fit the guard onto the trimmer head and push to secure
fitting.
Mounting the plant protector (Fig. 4)
Attached it like shown in the illustration.
Mounting of knife (Fig. 5)
The PolyCut knife should be mounted on the screw-
head and be pulled back to secure fitting. To remove
the knife, push it forward to unfix it.
Charging
The battery is not full charged when delivered, please
ensure it is fully charged before you use it the first time.
Charge it 2 hours the very first time.
If the machine cannot work when turn on the switch, it
means the battery is out of power. Recharge it.
Warning!
When the machine stops because of low power, do not
try to start it again. It can damage the battery.
Always disconnect battery before changing knife!

Operation

Use the grass trimmer to cut grass. It is not suitable for
cutting stronger weed or plants.
Adjust the support handle, so you have the best
possible control of the machine.
The grass trimmer has a telescopic shaft. Loosen the
lock, push or pull to adjust the length of shaft, and
tighten the lock again. See Fig. 6
To start the grass trimmer, activate the safety lock and
on/off switch (Fig. 1, pos. 1 and 2).
Stop the trimmer by releasing the of/off switch.
Allow at least 5 seconds for the knife to stop rotating.
Always hold both handles, when using the grass
trimmer!

Battery and charger

Warning: Do not try to disassemble, short circuit or put
it to extreme heat or fire, as it can cause serious inquiry
and permanent damage to the battery!
Important: To protect the battery from total
discharge, the machine will stop, when the battery is
nearly empty.
The machine must not be started up again after
automatic shutdown, as it can damage the battery.
The battery must be recharges before the work can
continue.
Charging
Only use the original charger which is included.
Before the battery is being used the first time, it is
recommended to fully charge it first.
Do not try to charge other type of batteries in the
charger, other than the original battery.
Keep the charger in a dry and warm environment
(10-25 degrees C) and only use it indoor. It should
be connected to a normal 230V AC socket.
The surface of the battery can become warm
during charging. This is normal.
Do not cover battery or charger during charging.
Allow free ventilation of air.
A fast charger is included with the machine. A full
charge takes around 60 min.
Charging step:
1.
Check that your mains voltage is the same as that
marked on the rating plate of the battery charger.
Insert the power plug of the adapter into the mains
socket outlet. The LED (b) on the adapter will turn
green.
2.
Insert the battery pack into the charger pedestal
(c). The LED will turn red at once. It means the
charger is working.
3.
After the completion of charging, the LED will turn
green.
Attention:
Remove battery from the charger during storage.
Avoid water/moisture near the charger.
Important: The charger will stop, when the battery is
full. However, it is not recommended to leave the
battery in charger for more than 24 hours.
It is recommended to drain the battery completely and
fully charge it whenever possible, as it can increase
the health of the battery. But partial charge will not
damage the battery.
9

Advertisement

Table of Contents
loading

Table of Contents