Olivetti d-Copia 5002MF Operation Manual page 200

Fax Settings > Default FAX settings
Item
Port 1/ RX Start Speed
Port
*1
2
ECM RX
Others RX Setting
Remote SW Dial
Encrypted
Reception
Reception Port
*1 This function is displayed when 2 optional FAX Kits (Dual FAX option) are installed.
Encryption Key Registration
[Home] key > [...] > [System Menu] > [Function Settings] > [Fax/iFax] > [Encryption Key Registration]
This is used to register an encryption key for encrypted communication.
Encryption (page 5-38)
Fax Communication Restriction
[Home] key > [...] > [System Menu] > [Function Settings] > [Fax/iFax] > [Fax Communication Restriction]
This function allows you to send or receive originals only when communication requirements are met.
Transmission Restriction (page 8-17)
Change the RX Start Speed.
When communication conditions are bad, the fax may not be received correctly. In
that case, set a lower RX Start Speed.
Value: 9600bps, 14400bps, 33600bps
NOTE
Normally this should be used with the default setting.
Set whether ECM RX is performed.
ECM is a communication mode specified by the ITU-T (International
Telecommunication Union) that retransmits data when an error occurs. Fax machines
that have ECM mode check for errors as they communicate, preventing distortion of
the image due to noise on the line and other conditions.
Value: On, Off
NOTE
When there is a large amount of noise on the line, communication may take slightly longer than
when [Off] is selected.
Select the reception mode.
Value: Auto (Normal), Auto (Fax/Phone), Auto (TAD), Auto (DRD), Manual RX
If Auto (DRD) is selected, select the DRD Pattern.
Value: Pattern 1 (Normal Ring), Pattern 2 (Double Ring),
Pattern 3 (Short-Short-Long), Pattern 4 (Short-Long-Short)
DRD reception mode is available for some countries.
FAX Reception (page 4-2)
Manual Reception (page 4-4)
DRD Reception (Available for some countries.) (page 5-46)
To start fax reception by operation from the connected telephone set, use the following
operation.
Value: 00 - 99
Remote Switch Function (page 5-50)
Turns on reception by encrypted communication.
Value: Off, On
If turned on, select the encryption key.
Encryption (page 5-38)
*1
You can make one of the 2 phone lines a receive-only line.
Value: Off, Port 1, Port 2
Reception Port Selection (page 9-3)
Description
8-13