HearthStone Ambiance Fireplaces Hipster 14 Owner's Manual page 24

Table of Contents

Advertisement

venting system frequently if using low burn rates
consistently.
MEDIUM LOW BURN: With the primary air control in
the low position, pull the air control forward (a little
less than 1/4"). A medium-low burn rate is the typical
setting and is preferable if the stove is unattended. At
this burn rate, a little goes a long way.
MEDIUM HIGH BURN: With the primary air control in
the low position, pull the air control forward (a little
less than 3/8")
HIGH BURN: Completely open the primary air control
by moving it all the way outward toward the operator.
Fully load the firebox with wood on a bed of hot coals
or on an actively flaming fire. To minimize creosote
accumulation, run the stove on high once or twice
daily for 35 to 45 minutes to fully heat the stovepipe
and chimney.
CAUTION: Do not burn fuel other than cordwood in
your stove.
O
-F
C
VER
IRE
AUTION
Over-firing
means the
temperatures above normal temperatures reached
during High Burns outlined in the BURN RATE
section. Carefully avoid over-firing, as it will damage
the stove. Symptoms of chronic over-firing can
include warped components, short burn times, a
roaring sound in the stove or stovepipe, and
discoloration of the stovepipe. A properly installed
stove using fuel and following operating procedures
as outlined in this manual should not over-fire.
Excessive draft, inappropriate fuel, and operator error
can cause over-firing. Correct an over-fire situation as
follows:
EXCESSIVE DRAFT: Contact your local dealer
to have a draft reading taken. Any draft in excess
of 0.1 WC requires a damper in the stovepipe.
Some installations may require more than one
damper.
INAPPROPRIATE FUEL: Do not burn coal; kiln
dried lumber, wax logs, compressed wood, highly
volatile fuels or combustibles, or anything other
than natural cordwood.
OPERATOR ERROR: Ensure all the gaskets are
in good condition.
compressed gaskets. Only burn the stove with
the firing and ash doors in the closed position.
If you suspect your stove is over-firing, discontinue
use and contact your dealer immediately. Damage
caused by over-firing is not covered by your
Ambiance
Fireplaces | Grills
stove is
operating at
Replace worn out or
warranty. Results of over-firing can include warped
or burned out internal parts, cracked refractory
panels, discolored or warped external parts, and
damaged finish.
ANY SIGNS OF OVER-FIRING WILL VOID YOUR
WARRANTY!
THE FRONT DOOR MUST REMAIN CLOSED WHEN
IN OPERATION
R
A
D
EMOVAL
ND
ISPOSAL
You can leave a thin layer of ashes in the firebox if
preferred. Allow fire to die down or go out completely.
It is important to prevent ashes from building up
around the front door opening or they will spill out, or
they can pack into the gasket channel and prevent
proper sealing. To remove ashes, use a fireplace
shovel. Avoid removing large live coals by pushing
them to the side and removing only the finer ash with
a shovel.
Disposal of ashes - Ashes should be placed directly
into a metal container with a tight fitting lid. Do not
place any other items or trash into the metal
container. Do not pour water into the container.
Replace the container's lid and allow the ashes to
cool. Never place the ash disposal container on a
combustible surface or vinyl flooring, as the container
could be hot!
Pending disposal, place the closed ash container on
a noncombustible floor or on the ground outside, well
away from all combustible materials, liquid fuels, or
vehicles. Retain ashes in the closed container until all
coals thoroughly cool.
If the ashes are disposed of by burial in soil or
otherwise locally dispersed, they should be retained
in the closed container until all cinders have
thoroughly cooled.
NEVER place ashes in wooden or plastic containers,
in trashcans with other trash, or in paper or plastic
bags, no matter how long the fire has been out.
Coals within a bed of ashes can remain hot for
several days once removed from the firebox.
24
O
A
F
SHES
Hipster 14 (8240 Model)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Amb8240

Table of Contents