Omron ZEN-8E Communications Manual page 22

SECTION 1 Communications Methods
Displaying the RS-485 Communications Submenu
STOP Mode
MO13:15 STOP
I:oooooo
(See
Q:[[[[
note.)
Main Menu
2
PROGRAM
RUN
PARAMETER
SET CLOCK
SET CLOCK
LANGUAGE
RS485
OTHER
Power
ON
2
5
● RS-485 Communications Submenu Setting Examples
RS-485 Communications Submenu
Power
NODE NO
ON COM SPEED
DATA BIT
STOP BIT
2
5
RS485
NODE NO
RUN
RS485
NODE NO
3 4 RUN
2
5
RS485
SET?
OK/ESC
(See
note.)
RUN
NODE NO
COM SPEED
DATA BIT
STOP BIT
6
The screen at the left will be displayed when the ZEN is in
STOP mode.
Press the OK Button to display the Menu Screen.
Note: This step is not required after switching from RUN
Press the Down Button to move the flashing cursor to
RS485.
Submenu
Press the OK Button to display the RS-485 Communica-
NODE NO
tions Submenu.
COM SPEED
→
DATA BIT
STOP BIT
↓
Press the Up and Down Buttons to move the flashing cur-
COM SPEED
sor to the items on the submenu.
DATA BIT
STOP BIT
PARITY
The RS-485 Communications Submenu Screen will be dis-
played when the power is turned ON. Use the Up and Down
Buttons to move the flashing cursor to NODE NO.
↓
Press the OK Button to display the currently set value. The
highlighted cursor will flash.
01
↓
Again press the OK Button. The highlighted cursor will be
changed to a flashing cursor, and the set value will be ready to
be changed.
09
Use the Right and Left Buttons to move the flashing cursor to
the digit that is to be changed.
Use the Up and Down Buttons to change the number.
↓
Press the OK Button. A message will be displayed to confirm
whether the changed setting is to be saved.
Note: The setting will not be saved if the ESC Button is
09
↓
Press the OK Button to save any changes and return to the RS-
485 Communications Submenu Screen.
Mode to STOP mode.
pressed.