Disassembling The Unit - Trane ProSpace PTEG0701GAA Installation, Operation And Maintenance Manual

Disassembling the Unit

1. Grasp filter and pull upwards to remove it from the
unit.
2. Remove the front panel from the unit by grasping
the bottom corners and gently pushing in to release
the cantilever snap joints.
3. Remove the seven (7) screws holding the grille.
4. Remove the three (3) screws holding the left bracket
and then remove the left bracket.
PTAC-SVX004A-EN
5. Remove the screw holding the guard board and pull
is upwards to remove it.
6. Remove the three (3) screws holding the right
bracket and then remove the right bracket.
7. Remove the four (4) screws holding the middle
connection board and then remove the middle
connection board.
8. Remove the six (6) screws holding the guard net
and then remove the guard net.
9. Remove the four (4) screws holding the top panel
sub-assembly and then remove the sub-assembly.
27