Attaching The Appliance To The Top Of The Cavity - Bosch B24IW50NSP Installation Instructions Manual

The height adjustable feet at the front and rear can all
be adjusted from the front.
Front: with open ended wrench
5
Rear: with / " (8 mm) hex nut driver
16
via flexible shaft.
CAUTION
d
Never use a cordless screwdriver!
A mark is attached to the appliance base and is used as
a standard gage for height adjustment. When adjusting
the height, align this mark at a height of 1¼" (32 mm)
above the floor.
Unscrew the height adjustable feet until the mark
q
on the base has reached the indicated guide
dimension (1¼" / 32 mm).
It is very important to comply with this dimension for
i
the subsequent alignment of the furniture fronts.
Align the furniture fronts with the spirit level.
q
i
-
1
/ " (SW13)
2
-
d
-
13. Attaching the appliance to the
q
Get other manuals https://www.bkmanuals.com
Note:
Do not twist or jam the appliance inside the cavity!
When unscrewing the height adjustable feet,
proceed gradually: Always alternate between left
and right, left and right, etc..
The adjustment of the rear feet is facilitated if the
appliance is unloaded at the rear.
If using a wooden beam as an alternative anti tip
device according to point 6 of this installation
manual, rotate the appliance all the way towards
the wooden beam.
top of the cavity
Screw the attachment plate lugs (top) to the
overhead furniture/fixtures.
27