Appendix; List Of Messages - Sony BRC-Z700 Operating Instructions Manual

Appendix

List of Messages

The following messages may appear on the screen. Take
the necessary measures shown below.
Indicators on the BRC-Z700 camera
Indicator Meaning/remedies
STANDBY lamp The camera stopped moving due to an
flashes. error in the pan/tilt mechanism. Reset
the pan/tilt position or turn off the power
of the camera and turn it on again.
The tally lamp Turn off the power of the camera, and
flashes. consult with your Sony dealer.
Messages for the BRC-Z700 camera
Message Meaning/remedies
Please restart system You are prompted to restart the power of
the camera after you changed the setting
of "IMG-FLIP" in the SYSTEM menu.
Use the POWER switch on the supplied
Remote Commander or the POWER
button on the RM-BR300 Remote
Control Unit to turn the power off, then
on. The changed setting becomes
effective.
PRESET xx OK When you store the camera settings into
(xx = preset position the memory (POSITION 1-16), the
numbers 01 to 16) message will appear for 2 seconds.
One Push WB...OK While the white balance is automatically
(NG) adjusted, the message will appear. Wait
for a while. When the adjustment is
complete, it will disappear.
STOP Turn off the power of the camera, and
(The message will consult with your Sony dealer.
flash in FAN
MOTOR on PAGE6
in the STATUS
menu.)
CAUTION Turn off the power of the camera, and
COOLING FAN 1 consult with your Sony dealer.
(2), (1, 2)
STOPPED!
*[ENTER]: EXIT This message appears while you adjust H
PHASE in the SYSTEM menu. To exit
from the adjustment, press the HOME
button on the Remote Commander or the
button on the top of the joystick on the
Remote Control Unit.
*PUSH ENTER This message appears when you move
BUTTON the cursor to H PHASE in the SYSTEM
menu. To start the H PHASE adjustment,
press the HOME button on the Remote
Commander or the button on the top of
the joystick on the Remote Control Unit.
70
List of Messages
Message Meaning/remedies
PRESET (xx) OUT This message appears when you preset
OF RANGE (xx = the camera position when the pan/tilt
preset position position of the camera is out of range of
numbers 01 to 16) the current PAN-TILT LIMIT setting.
This camera position presetting will fail
to be performed. Perform the presetting
again after moving the camera within the
range of the PAN-TILT LIMIT setting.
Error messages for the BRU-H700 HD Optical
Multiplex Unit
Message Meaning/remedies
Communication error The message will appear when the HD
Please check Optical Multiplex Unit is turned on, if a
connection problem occurs in the connection of the
Optical Fiber Cable between the camera
and the HD Optical Multiplex Unit.
Turn off the power of the camera and
the HD Optical Multiplex Unit, check
the connection of the Optical Fiber
Cable and turn the powers on again.
This message will also appear when the
power of the camera is not turned on.
Turn off the HD Optical Multiplex Unit,
turn on the camera, then turn on the HD
Optical Multiplex Unit again.
Option card error The message will appear when an
Please check option Interface Board that cannot be used with
card the HD Optical Multiplex Unit is
inserted into the card slot. Turn off the
power of the HD Optical Multiplex Unit
and remove the board.
CAUTION Turn off the power of the camera, and
COOLING FAN consult with your Sony dealer.
STOPPED!