NETGEAR WAX618-111NAS User Manual page 25

Insight Managed WiFi 6 AX3000 Access Point Model WAX618
6. Add a new network location where you want to add the access point by tapping the
Next button, and then tapping OK.
You can also select an existing network location.
The device admin password that you entered for the new network location replaces
the existing admin password on all devices that you add to the network location.
In most situations, Insight detects the access point automatically, which can take
several minutes.
7. To add the access point to your network location, do one of the following:
• If the access point is automatically detected and listed in the Insight Manageable
Devices section, tap the icon for the access point, and then tap the ADD DEVICE
button.
• If the access point is not automatically detected, or you prefer to use another
method to add the access point, tap the + icon in the top bar, and do one of the
following:
- Tap the SCAN BARCODE OR QR CODE button, and then scan the access
point's code, which is on the access point label.
- Tap the Enter Serial Number and MAC Address link, and then manually
enter the access point's serial number and MAC address, which are on the
access point label.
8. If prompted, name the access point and tap the Next button.
The access point automatically updates to the latest Insight firmware and Insight
location configuration. This might take up to 10 minutes, during which time the
access point will restart.
The access point is now an Insight-managed device that is connected to the Insight
cloud-based management platform. If the Power/Cloud LED was solid green, it lights
solid blue.
You can use the Insight Cloud Portal or Insight app to configure and manage the
access point.
Install the Access Point in Your
Network and Access It for Initial
Configuration
25 User Manual