Installing The I/O Board - Shipped With Flexible Printed Circuit (Fpc) - Dell G15 5510 Service Manual

NOTE: System board can be removed with the heat sink, I/O board, and USB board attached.
About this task
The following image indicates the location of the I/O board and provides a visual representation of the removal procedure.
Steps
1. Turn the system board over.
2. Remove the two screws (M2x4) that secure the I/O board to the system board.
3. Remove the I/O board from the system board.
Installing the I/O board - shipped with flexible printed circuit
(FPC)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the I/O board and provides a visual representation of the installation procedure.
28 Removing and installing components