Description Of Operations; Installation Procedure; Powering Up The Instruments; Use Of The Instrument - ASSEMBLAD INFRAGAS-196 Operating Manual

Assemblad
2

DESCRIPTION OF OPERATIONS

2.1

INSTALLATION PROCEDURE

Remove the instruments from its package, install it on a trolley and connect accessories
as follows:
- connect RPM inductive probe, if provided, to the RPM connector placed on rear
panel;
- connect gas hose to the gas takeup tip being sure that the arrow on the filter
placed on the hose is in the direction of gas flow, then connect the other side of
the hose to the condensate filter on rear panel;
- connect temperature probe (*), if provided, to the rear panel connector;
Leave accessories always connected to the instrument, even if not used, to speed up
operations.
Warning:
once unpacked, the instrument may have internal NiCd battery discharged; this means
that real-time clock (*) has no date / time or a date / time value incorrect. In this case the
instrument must be connected to power and left powered on continuously for 24 hours to
insure full charge to internal NiCd battery. Then follow instructions to setup real-time clock.
2.2

POWERING UP THE INSTRUMENTS

Connect the line power cord to the instrument and switch it on; the instrument starts
printing the preamble. Wait for 15 min. (15 min it is the max. time) of warm-up time before
to start measurements on gases. The "FUNC" display show the warm-up time remaining.
Warm-up procedure doesn't stop until the analyzer reach the requested temperature.
After this procedure the analyzer automatically performs a self-calibration then it will pass
to the exhaustion stage.
2.3

USE OF THE INSTRUMENT

1) After switching on, the instrument automatically sets to the following conditions:
- 4-stroke engine type (RPM selection)
- O2 display (FUNCTION selection)
ASSEMBLAD S.r.l. - Costruzioni Elettroniche - Via Marzabotto, 4 - 50013 Campi Bisenzio - Firenze - Italy
Tel. +39-055-890485 - Fax +39-055-890496 - E-mail: info@assemblad.it - Web: www.assemblad.it
Infragas-196 and Infragas-196 PC-Module * Operating manual
12