Table of Contents
Advertisement
Fast Ethernet SFP Transceiver Modules
MFB-FX
SFP-Port 100BASE-FX Transceiver (1310nm) -2km
MFB-F20
SFP-Port 100BASE-FX Transceiver (1310nm) - 20km
MFB-FA20 SFP-Port 100BASE-BX Transceiver (WDM,TX:1310nm) -20km
MFB-FB20 SFP-Port 100BASE-BX Transceiver (WDM,TX:1550nm) -20km
MFB-F40
SFP-Port 100BASE-FX Transceiver (1310nm) – 40km
MFB-F60
SFP-Port 100BASE-FX Transceiver (1310nm) – 60km
It is recommended to use PLANET SFP on the Managed Switch. If you insert an
SFP transceiver that is not supported, the Managed Switch will not recognize it.
In the installation steps below, this Manual uses Gigabit SFP transceiver as an example. However,
the steps for Fast Ethernet SFP transceiver are similar.
1.
Before we connect Managed Switch to the other network device, we have to make sure both sides of the SFP
transceivers are with the same media type, for example: 1000BASE-SX to 1000BASE-SX, 1000BASE-LX to
1000BASE-LX.
2.
Check whether the fiber-optic cable type matches with the SFP transceiver requirement.
To connect to 1000BASE-SX SFP transceiver, please use the multi-mode fiber cable with one side being the male
duplex LC connector type.
To connect to 1000BASE-LX SFP transceiver, please use the single-mode fiber cable with one side being the male
duplex LC connector type.
Connecting the Fiber Cable
1.
Insert the duplex LC connector into the SFP transceiver.
2.
Connect the other end of the cable to a device with SFP transceiver installed.
3.
Check the LNK/ACT LED of the SFP slot on the front of the Managed Switch. Ensure that the SFP transceiver is operating
correctly.
4.
Check the Link mode of the SFP port if the link fails. To function with some fiber-NICs or Media Converters, user has to set
the port Link mode to "1000 Force" or "100 Force".
User's Manual of GS-4210 Series
61
Advertisement
Table of Contents
