Turning On The Printer - Canon imagePROGRAF GP-540 Setup Manual

5

Turning On the Printer

1
Open the top cover.
3
Remove the tape and protective material.
●
Peel off the tape affixed to the carriage, and then pull the
protective material (the area shown shaded in the diagram)
towards you and remove it. Remove the protective sheet if there
is one attached.
5
Connect the power cord to the printer.
●
Insert the power cord into the power connector on the rear of the printer.
For the GP-520
2
Pull up and remove the belt stopper.
●
Keep the belt stopper for future use. You will need it in case you
move the printer to another location.
4
Close the top cover.
For the GP-540
5