Dear Customer Thank you for buying our range hood. Please read the user manual carefully and store in a handy place for later reference. This hood is designed for install on walls. Read the following carefully to avoid damage or injury. SAFETY AND WARNINGS ●...
Page 4
or hot air duct containing combustion fumes from burning gas or other fuels. Confirm that room ventilation is appropriate with the local authorities. ● The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels ●...
external timer or separate remote control system. ● There shall be adequate ventilation of the room when the hood is used at the same time as appliances burning gas or other fuels. Ensure that the negative pressure of the installation site does not exceed 4 Pa (0.04 mbar) to ensure combustion fumes are not drawn back into the room.
Drilling holes ● Mark the location for flue cover wall mounting brackets, rangehood mounting points and anti-tilt fixing points above the rangehood using the base as the reference point (Fig. 1). 250 mm Upper chimney extension bracket attachment points 250 mm Chimney bracket attachment points 250 mm...
Page 9
Fig.2 Attached hood on wall ● Remove the aluminium filters from the rangehood body and hang it on the mounting screws then secure at the anti-tilt locations as indicated in Fig. 3. Fig.3...
Page 10
Connect ducting adapter ● Connect Ø150mm ducting adapter to the blower outlet and use screws ST 4x12mm to fix it to the range hood (Fig. 4). Ø150 to Ø125mm adapter Ø150mm Ducting adapter Fig.4 ● If necessory, connect the Ø150 to Ø125mm adapter to the Ø150mm ducting adapter (Fig.
Page 11
Attach the chimney Fig.6 Connect ducting adapter ● Fix the chimney to the top bracket using two screws ST 4x12mm. Connect top of the ducting tube to vent kit as per manufacturers instructions (Fig. 7). ● Install back the aluminium filters to rangehood, and remove the protection film from rangehood and chimney.
OPERATING INSTRUCTIONS ● Turn the hood on for a few minutes before you start cooking. ● The hood should be left on for a minimum of 5 minutes after cooking or until all odours have dispersed. Control panel features 1 – Filter clean warning display/button. Remind to replace the filter after the extractor fan working 50 hours.
Page 13
FUSE 10’ from the manufacturer. 1 MONTH ≤ 65ºC...
Replacing Activated charcoal filters Replace Activated charcoal every 3 months 3 MONTHS Troubleshooting Problem Possible cause Solution Excessive vibration. The appliance is not installed Take down the appliance and check properly on the brackets. The fan blade is damaged. Switch off the appliance. Repair to The light is on, but the The fan blade is jammed.
Recycling & disposal The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.
記 列 資 Model No.: 型 Serial No.: ⾝ 編 Dealer: 經 商 稱 Date of Purchase: 購 Invoice No.: 單 編 本產品不斷改進中,如功能有所更改,恕不另行通知 如有疑問,請與客戶服務中心聯絡。不便之處,敬請原諒。 The product specifications may be changed without prior notice. Please contact customer service for details if necessary. 說明書內容以英文版本為準...
Need help?
Do you have a question about the PC900SLE and is the answer not in the manual?
Questions and answers