Subscribe to Our Youtube Channel
Related Manuals for Philco PC700SNL
Summary of Contents for Philco PC700SNL
- Page 1 INSTALLATION 660mm top of cooking surface Positioning Fixing dimensions WARNING! these instructions may result in electrical hazards.
- Page 2 Drilling holes ● Mark the location for flue cover wall mounting brackets, rangehood mounting points and anti-tilt fixing points above the rangehood using the base as the reference point (Fig. 1). Fig.1 Attach chimney brackets and hood mounting screws ● Attach the upper hood mounting screws in the locations shown in Fig.2.
- Page 3 Screws ST3.9 x 32mm Fig.2 Attached hood on wall ● Remove the aluminium filters from the rangehood body and hang it on the ST3.9 x 32mm screws then secure at the anti-tilt locations as indicated in Fig. 3. Fig.3...
- Page 4 Connect ducting adapter ● Connect Ø120mm ducting adapter to the blower outlet and use ST3.9 x 13mm screws to fix it to the range hood (Fig. 4). Screws ST3.9 x 13mm Ø120mm Ducting adapter Fig.4 Fixing flexible duct ● If need exhaust air to the outside. Connect Ø125 mm flexible duct to the adapter and fix it (Fig.
- Page 5 Attach the chimney Fig.6 Connect ducting adapter ● Fix the chimney to the top bracket using the ST3.9 x 13mm screws. Connect top of the ducting tube to vent kit as per manufacturers instructions (Fig. 7). ● Install back the aluminium filters to rangehood, and for Stainless Steel appliance, remove the protection film from rangehood and chimney.
- Page 7 裝上煙囪ST3.9 x 32毫米螺絲安裝在圖2的所示位置。如安裝至磚 石上，請使用Ø6 x 30毫米膨脹膠塞。...
- Page 8 ST3.9 x 32毫米...
- Page 9 將Ø120毫米排氣管接合器連接在排風口上，並用ST3.9 x 13毫米 螺絲固定在抽油煙機上(圖4)。 Ø125毫米的 伸縮排氣管連接在接合器上，並用螺 絲固定位置。...
- Page 10 安裝煙囪 圖6 連接煙囪 將煙囪固定在頂部支架上，用ST3.9 x 13 毫米螺絲安裝及固定。將排氣管的頂 部連接到支架上(圖7)。 將金屬隔油網裝回抽油煙機上，並 將其保護膜取下。 圖...
Need help?
Do you have a question about the PC700SNL and is the answer not in the manual?
Questions and answers