Trane Mitsubishi Electric TPEFYP006MA143A Technical And Service Manual page 37

[ VIII Troubleshooting ]
2. Capacity code setting
(1) SW2
1) Indoor control board
Dipswitch settings must be made while the unit is stopped.
Factory setting
The switches are set to correspond to the unit capacity.
TPEFYP006MA143A TPEFYP008MA143A
ON
1 2 3 4 5 6
TPEFYP018MA143A TPEFYP024MA143A
ON
1 2 3 4 5 6
TPEFYP036MA143A TPEFYP048MA143A
ON
1 2 3 4 5 6
3. Model setting
(1) SW4
1) Indoor control board
Dipswitch settings must be made while the unit is stopped.
Factory setting
ON
1 2 3
Note:
Changes made to the dipswitches SW1, SW2, and SW3 will become effective when the unit comes to a stop (remote controller
off). There is no need to power cycle the unit.
4. Power voltage setting
(1) SW5
1) Indoor control board
Dipswitch settings must be operated with the main power turned OFF.
Factory setting
220V
(208V)
240V
(230V)
ON
The figure at left shows that the switches 1 through 5 are set to ON and 6 through 10 are set to OFF.
1 2 3 4 5 6 7 8 9 10
1
1
The figure at left shows that the switch is set to 1.
2
2
3
HWE1832A
TPEFYP012MA143A
ON ON
1 2 3 4 5 6 1
TPEFYP027MA143A
ON ON
1 2 3 4 5 6 1
TPEFYP054MA143A
ON ON
1 2 3 4 5 6 1
4 5 6 7 8 9 10
Set SW5 to 240V side when the power supply is 230 volts.
When the power supply is 208 volts, set SW5 to 220V side.
TPEFYP015MA143A
ON
2 3 4 5 6 1 2 3
TPEFYP030MA143A
ON
2 3 4 5 6 1 2 3
2 3 4 5 6
- 30 -
4 5 6
4 5 6
GB